![]() Go HERE for more filter element information.CLICK HERE for a third party installation videoĬlick here for the discontinued 20-031X-XX EVO X fuel hanger instructions PTFE -8AN hoses attach to a Radium Engineering fuel filter that mounts underneath the vehicle using a specifically designed EVO 7-8-9 bolt-on bracket.ĭepending on the kit selected (-01,-03,-05), the fuel filter will be assembled with 1 of 3 different elements. This includes a pre-made PTFE -8AN feed line from the hanger up to the engine bay and the kit re-uses the factory feed line as the regulator return line. The plumbing kits include everything required to connect directly to an aftermarket (-8AN male) fuel rail and (-6AN male) FPR for both single and dual pump configurations. NOTE: the optional fuel hanger plumbing kits listed below include this necessary post pump filter.Ģ0-0376-0X FUEL HANGER PLUMBING KIT, EVO 7-8-9 A low micron aftermarket fuel filter should be installed downstream to protect the injectors from debris. NOTE: This kit eliminates the OEM hanger's "post" fuel pump filter. A pliable fuel pump filter sock like this HERE must be used for proper fitment. Depending on the setup, some parts will simply not be used (20-0345-10 shown below). There will be enough components included with this option to use 1 or 2 fuel pumps. Electrical Hardware for Fuel Pumps and OEM Sender Anodized Aluminum Dual Pump and Fuel Sender Bracket 6AN Male and OEM Compatible FPR Inlet Fittings 8AN Male and OEM Compatible Pump Outlet Fittings Venturi Jet Pump with Pressure Relief Valve Select qty1 for single pump applications and qty2 for dual pump applications. Fuel pump wiring kits can be purchased HERE. Single pump applications can reuse the OEM fuel pump controller wiring, but it is recommended to upgrade the OEM wiring as these high flow fuel pumps draw additional current requiring larger gauge wire. The Radium fuel pump hanger includes a venturi jet pump with a new integrated pressure-relief valve to minimize back pressure.Īll returning fuel from the pressure regulator and crossover hose exit the jet pump keeping the OEM gas tank baffle full for starvation protection. When using aftermarket high-flow fuel pumps, the OEM jet pump becomes too restrictive creating unwanted backpressure in the regulator return line causing excessive fuel rail pressure. One major issue with the OEM EVO 7-8-9 fuel pump hanger is the restrictive return port and venturi jet pump. Electrical hardware is included for the fuel pump(s) and OEM level sender. ![]() Furthermore, the high quality in-tank wiring is insulated with chemically resistant ETFE. The low profile design keeps all wiring tucked nicely underneath the OEM cover plate. Nonconductive acorn nuts are provided to prevent any accidental short circuits. These serviceable connections are properly sealed and impervious to all standard and exotic fuels. The custom designed stainless electrical studs easily handle the high current demand that compact bulkhead connectors lack. This system is ONLY compatible with the following pumps: However the preassembled adapter fittings are compatible with the OEM fuel lines. A single 8AN male pump feed port and 6AN male return port simplify aftermarket -AN hose plumbing. The machined assembly drops-in the factory fuel tank replacing the OEM hold-down flange. The Radium Engineering fuel pump hanger allows the use of 1 or 2 aftermarket pumps in the stock Mitsubishi Evo 7-8-9 fuel tank.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |